![]() Once the bolt is out, you should be able to move the slide forward to the point where it lifts off the frame. It may take some force if the pistol has not been taken apart in a while.Ĥ. If you hit that with the dowel rod the bolt will move out. You'll see two "rails' that hold the round down. With the gun upside down, place a dowel rod or similar object(as long as it's softer than steel) down through the magazine(where the clip goes) and against the bottom of the bolt. This is to keep the slide from pushing the bolt against the barrel so you'll be able to knock the bolt out. Once the pin is out, place a small object(like a pen) under and up the rear bottom part of the slide after pulling the slide back. To do this place the pistol on it's right side on two pieces of wood leaving a gap where the pin will move when you drive it outĢ. ![]() Using an 1/8-inch pin punch drive out the pin that goes through the bolt to hold the bolt in place driving it from left to right. (This is to be done with the gun unloaded and the clip removed).ġ. 380 Backup Single Action disassembly and cleaning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |